cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
496
Views
5
Helpful
6
Replies
Sergey 1907
Beginner

SIP trunk CUCM to CUCM down local=0

I have a SIP trunk to CUCM 9 server 192.168.0.10 from CUCM 12.5(SU4) server 172.16.10.243 through a tunnel (Media Termination Point Required cheсked). Ping goes in both directions, telnet to port 5060 are open. The WWW control pages CUCM's are available, the call manager service is running and the SIP profile is in TCP mode. Everything seems to work but!
SIP trunk status down and Status reason local = 0
What could be? what's the status??

1 ACCEPTED SOLUTION

Accepted Solutions
Sergey 1907
Beginner

I have solved this problem. On the other side, the Translation pattern would not be configured. And also on ASA there was an inspection for streaming protocols

View solution in original post

6 REPLIES 6
Roger Kallberg
VIP Advisor

A few things to check.

  • Are there more nodes in the cluster? If so are all of them defined as targets on the trunk?
  • Do you have "Run on all nodes" set?
  • Are each side of the trunk setup to use SIP option ping?

Those would be the top of mind things to check based on the given information.

Please rate all useful posts

Hi Roger

1) Yes and Yes

2) Of course

3) Yes

What is Status reason local = 0 (Status reason local = 1 2 3 i know )) )?

Not sure what local = 0 means, I can't find any reference for that either.

Please rate all useful posts

I also searched, but could not find (((

sip.jpg

its a bug. Have a look on bug ID CSCuy59701

 

 

Please Rate all useful post :)
If this answered your question, please click "ACCEPT AS SOLUTION" Or If you find this response useful, please mark it as "HELPFUL"
Sergey 1907
Beginner

I have solved this problem. On the other side, the Translation pattern would not be configured. And also on ASA there was an inspection for streaming protocols

View solution in original post

Content for Community-Ad

Spotlight Awards 2021