06-20-2016 10:39 AM - edited 03-19-2019 11:16 AM
Hello,
I am able to get GUI for my CUE, but when I try to log-in it displays "Login Failed". I created user "hvelazquez" and give it group Administrators privileges.
I have his information in the running:
groupname Administrators member hvelazquez
(hvelazquez has a password and belogs to Administrators group. This is the one I am using for testing)
se-10-1-10-1# sh inter
GigabitEthernet 0 is up, line protocol is up
Internet address is 10.1.10.1 mask 255.255.255.252 (configured on router)
0 packets input, 0 bytes
0 input errors, 0 dropped, 0 overrun, 0 frame errors
0 packets output, 0 bytes
0 output errors, 0 dropped, 0 overrun, 0 collision errors
0 output carrier detect errors
interface Integrated-Service-Engine0/0
description Interface used to manage integrated application modulecue is initialized with default IMAP group
ip unnumbered Vlan90
ip virtual-reassembly
service-module ip address 10.1.10.1 255.255.255.252
service-module ip default-gateway 10.1.10.2
!
end
UC560IP_NAU#sh run interface vlan 90
Building configuration...
Current configuration : 88 bytes
!
interface Vlan90
ip address 10.1.10.2 255.255.255.252
ip virtual-reassembly
!
end
CUE version: 8.6.5
Solved! Go to Solution.
06-20-2016 02:00 PM
File privilege level is 15 by default however you can set it to 0 on router and test.
Have you tried with web admin account which you have set inside telephony service.
You can refer to this link for similar issue.Thanks
06-20-2016 12:52 PM
Hi,
Have you tried file privilege 0 command on the CME ? also can you provide sh run as well.thanks
06-20-2016 01:15 PM
Hello Again Deepak.
This CUE is implemented under service-module integrated-Service-Engine 0/0 session.
Groupname: Administrators
Full Name: Administrators*
Description: System administrators group
Phone:
Phone(E.164):
Fax:
Email:
Epage:
Language: systemDefault
Group Members: <none>
User Members: hvelazquez lolivo rflores
Group Owners: <none>
User Owners: <none>
Privileges: superuser
Sorry, I did not understand your suggestion. Where do I supposed to type that command? Attached are the sh run for the gateway and the show run for foy module (CUE).
06-20-2016 02:00 PM
File privilege level is 15 by default however you can set it to 0 on router and test.
Have you tried with web admin account which you have set inside telephony service.
You can refer to this link for similar issue.Thanks
06-20-2016 02:04 PM
Thank you, Deepak.
I tried with the user I have under telephony service and it worked.
Kind regars,
Heriberto.
06-20-2016 02:15 PM
You are welcome my friend.
Cheers!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: