cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
196
Views
0
Helpful
2
Replies
Highlighted
Beginner

UNITY-D/120JCTLS=, Same PN but Different Cards?

I'm doing an analog integration into a PBX using a MCS-7835H-3.0-ECS1. I'm putting in a single D/41E and dual D/120JCT cards.

The D/41E and one D/120 shipped with the correct universal PCI interface. The second D/120 shipped with a standard PCI interface. Did I get an old card or is there a PN goof? Both D/120JCT cards have the UNITY-D/120JCTLS= PN on the cisco box. Pictures attached. Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

I believe Cisco still sells and ships the older non-Universal PCI version of the D/120 board because the uPCI version is not compatible with Unity 3.x. For Unity 4.x you should be using the uPCI version and the part number for that is UNITY-D/120U-LS=.

Regards,

Eric

View solution in original post

2 REPLIES 2
Highlighted
Cisco Employee

I believe Cisco still sells and ships the older non-Universal PCI version of the D/120 board because the uPCI version is not compatible with Unity 3.x. For Unity 4.x you should be using the uPCI version and the part number for that is UNITY-D/120U-LS=.

Regards,

Eric

View solution in original post

Highlighted

Great! Thanks for the info.

Content for Community-Ad