I had installed a new Unity 4.0(4) in a old CCM cluster 3.3(5)
I have configured Unity but I below detail the problem:
I can leave vm in the cisco phones but I cannot hear anythinq when I dial the voice pilot number in the cisco phone. The status monitor of Unity display the vm port busy when I dialled the voice pilot number but the phone didn?t receive packet.(only send it)
In the CCM the ip address of the vm ports are 164.x.x.x (arpa). Is it normal?.
I cleanned arpa table with arp -d* in the unity and ccm servers
but I obtained the same fault 164.x.x.x the voice mail port in the CCM . I rebuilt the vm ports with the same result
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...