cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
544
Views
0
Helpful
1
Replies
Highlighted

utils dbreplication setrepltimeout

Hello everyone,

 

I need to upgrade a CUCM 9.1 to 10.5 i read  Cisco Upgrade Guide that i need to increase the timeout of the CUCM DB replication  for the  upgrade i need some advice:

 

I need to put the command "utils dbreplication setrepltimeout" on all my nodes or only to my Publisher?

I need to put the command before the upgrade?

i need to put the default value after the switch version or when i have the new version?

what value recommend 7200?

I need to use the command "utils dbreplication stop all" and later the command "utils dbreplication repair all" on my publisher?

 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Advisor

Hi Jorge

 

I do not think we need to change this value.I have been doing upgradations in the past but never changed .

regds,

aman

View solution in original post

1 REPLY 1
Highlighted
Advisor

Hi Jorge

 

I do not think we need to change this value.I have been doing upgradations in the past but never changed .

regds,

aman

View solution in original post

Content for Community-Ad