cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1835
Views
0
Helpful
2
Replies
Highlighted
Beginner

V-CUBE - running on UCS

Hi

Just wanted to see if anyone out there may have tried this or if anyone has any recommendations.

I am looking to see if its possible to run Virtual Cube on the same UCS box that hosts CUCM cluster.

Is this a no-can-do or is there a recommended approach to look at? The idea being of course that the Cube will be our Demarc line to the carrier, I'm just not sure if its a good or bad approach to try.

Thank you

FF

2 REPLIES 2
Highlighted
Cisco Employee

Refer below:

http://docwiki.cisco.com/wiki/Unified_Communications_Virtualization_Sizing_Guidelines

Regards

Deepak

Highlighted
Contributor

I can't say I have done this before, but this link might help you:

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book/voi-virtual-cube.html 

 

It said that virtual CUBE integrated into the Cisco CSR 1000V routers runs on a hypervisor on the Cisco UCS. It works with the ESXi hypervisors supported by Cisco CSR 1000V Series router and is supported on the a few of the UCS configurations. 

Content for Community-Ad