cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

1269
Views
0
Helpful
5
Replies
Beginner

VG248 Support for SIP

Hello,

My client has a VG248 that he is currently using for fax and he is migrating to SIP Trunking solution, My question is that is VG248 supported with SIP?

Any supporting document with the answer will be appreciated.

Thanks, Kind Regards

Shabbir

Everyone's tags (2)
2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Cisco Employee

Re: VG248 Support for SIP

Vg248 is a SCCP only device.

Protocols Supported

Skinny Client Control Protocol (SCCP)

http://www.cisco.com/en/US/partner/products/hw/gatecont/ps2250/products_data_sheet09186a008007c9bb.html

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

Beginner

Re: VG248 Support for SIP

No changes needed on vg248 to send calls via SIP trunk from CUCM...just make sure no one tries

to do t38 fax relay...that will not work.

View solution in original post

5 REPLIES 5
Hall of Fame Cisco Employee

Re: VG248 Support for SIP

Vg248 is a SCCP only device.

Protocols Supported

Skinny Client Control Protocol (SCCP)

http://www.cisco.com/en/US/partner/products/hw/gatecont/ps2250/products_data_sheet09186a008007c9bb.html

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

Highlighted
Beginner

Re: VG248 Support for SIP

Excellent,

Thanks so much for your help.

Beginner

Re: VG248 Support for SIP

Hey,

Thanks for your reply.

So if that's the case then if I replace my PRI circuits with SIP trunks, do I need additional config on my VG248 to make the fax work? Cuz technically for CUCM it's just a skinny endpoint and actually call SIP is SIP is done on the CUCM side.

Thanks again

Beginner

Re: VG248 Support for SIP

No changes needed on vg248 to send calls via SIP trunk from CUCM...just make sure no one tries

to do t38 fax relay...that will not work.

View solution in original post

Beginner

Re: VG248 Support for SIP

Thanks so much guys!!

Appreciate your help.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here