Hi Guys
I am trying to configure SIP - Xlite on the CME but when configuring - but getting the error configure first line first. The error is in Red below.
voice service voip
no ip address trusted authenticate
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
sip
bind control source-interface GigabitEthernet0/0/0
bind media source-interface GigabitEthernet0/0/0
registrar server
voice register global
mode cme
source-address 192.168.8.253 port 5060
max-dn 1200
max-pool 475
load 3905 CP3905.9-4-1SR3.loads
authenticate register
authenticate realm local
tftp-path flash:
auto-register
voice register dn 100
number 1000
name Adrian
!
voice register pool 100
id mac XXXX.XXXX.XXXX
dtmf-relay rtp-nte sip-notify
username 1000 password 1000
description Adrian
codec g711ulaw
no vad
The error I am getting is:
VoIP#config t
Enter configuration commands, one per line. End with CNTL/Z.
VoIP(config)#voice register pool 100
VoIP(config-register-pool)#number 100 dn 100
Please configure first line first
VoIP(config-register-pool)#
We will be most grateful for your advice.
Regards