The Cisco UCS Diagnostics software for Cisco UCS Blade Servers enables you to run tests on the hardware and verify the health of the components. The tool provides a variety of tests to exercise and stress the hardware subsystems on Cisco UCS Blade Servers. These tests can be run through the tool GUI or a CLI.
The subsystems it can test are
Storage (servers with MegaRAID controllers)
You can use the tool to run regression tests on the Cisco UCS Blade Servers after fixing or replacing hardware components. You can also use this tool to run comprehensive burn-in tests on Cisco UCS Blade Servers before deploying them in production environments.
I have a few rack-mount servers (C220 M3) spread around our data center, with Flash based CIMC GUI. To get around the Flash problem, I was thinking about hocking them up to a UCS manager (UCS 6248UP: which uses HTML5 instead of Flash). What is t...
I am having some strange problem in my cisco ucs 240 m5. There are total of 24 disk installed on the server. Every thing was good until yesterday. 4 hardisk (SAS) suddenly went missing from OS and CIMC. Upon checking the server the led is ok(green and no ...
I'm attempting to bind a service profile to a new service profile template, but I'm receiving the following error: "not enough resources overall...cannot derive MAC address from virtualized port".The template uses a LAN Connectivity Policy that defin...
I moved a pair of FIs from a DR data center and was hoping to make use of them. But I noticed warningsabout ethernet port usage being in grace period. Will the ports stop working if in "grace period" state?Perhaps the engineer who installed these just nev...