Unified Computing System Discussions

I am hoping experts on this forum can help me understand how the following actions led to a situation where no traffic was being forwarded on a pair of 6509's configured in a VSS topology.   I have a UCS domain, 6296UP interconnects, cross connected ...

Can someone guide or provide any documentation on how to I clear old faults on UCS B series. I have worked hard to ensure the system in a good and healthy state. All these faults were generated when the system was initially installed and racked at cu...

Ok, I recently upgrade my two production UCS system to 2.1.2a and now I'm gettting this F1237 error, (voltage threshold cross) on two of my servers blades.  There doesn't seem to be much info on this error ... anyone have some insight?Thanks,Cy.     ...

As you can see under the new HTML5 interface, when selecting LAN > VLANs, the resize toggle does not actually resize the VLAN pane but instead leaves a white empty space. It doesn't prevent work from being done, but it's frustrating when you have lot...

Hi , I have UCSC240M4S need to be managed by Cisco Prime Network 4.2.2 Cisco Prime Network TAC engineer say UCSC240M4S  CIMC SSH response too slow.   I using SecureCRT  and putty to connect CIMC IP. it need about 9 - 15 seconds to prompt "Login as:" ...

i am new to tidal and any input's on below clariifcations 1)what is meant by Deferred status for a job in Tidal and when a job will go to this status with an example? 2)Let us say job A is schedually on daily basis.If Job A is aborted(completed abnor...

Does the memory below work on the UCS B200 M4s?  (Samsung M393A8G40D40-CRB 64GB DDR4-2133 8Rx4 LP ECC TSV RDIMM Server Memory)

L.S.,Since a couple of days the following error has been popping up in the event log (it clears after a while). <eventRecord affected="sys/mgmt-entity-A" cause="device-shared-storage-IO-error" changeSet="" childAction="deleteNonPresent" code="E419653...

I have the fairly common situation that I need to setup a disjoint layer 2 network on our UCS (UCSM 2.1(3b)) I've been careful to follow the documentation as closely as I can, but as soon as I assign a VLAN to an uplink interface ALL traffic stops ro...

Hi,I am unable to my Launch UCS Manager. It was working perfectly until two days ago when:I upgraded from UCM Firmware 1.3 to 2.02rI updated my JavaEverytime I click on 'Launch UCS Manager', I get the error below. What could be the problem?? Thanks.

Hi Everybody.... Hope all are doing fine. i have a query regarding to UCS Central 1.3.1b version. i am Installing it in cluster mode. after setting up first Node when i continue to Setup second Node its giving Error  "Peer UCS Central Node could not ...

Hi all, Client has Two UCS5108 chassis with eight UCS-B200-M3 servers each are installed on datacenter. The UCS chassis are connected to two UCS6248 fabric-interconnects for redundancy. Every UCS-IF is connected through vPC to the two Nexus5Ks switch...