Unified Computing System Discussions

I need to go from 2.1(1) to 2.2(3) - but there are complications, and I believe I need to do a manual update, instead of auto install. I've read through the http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/upgrading/from2-1/to2-2/b_Upgra...

I've always used HP proliant servers.  When we had a hardware failure (drive, RAM, CPU, temp, etc) the servers would email me and let me know.Is this possible w/ my new C220 M3 servers?  I have checked all over the CIMC interface and can't find anyth...

I'm creating some virtual NICs for ESXi hosts. What is the maximum bandwidth per virtual NIC? If I have 4 virtual NICs on a virtual switch in ESXi, what is the maximum bandwidth for the total of the 4 virtual NICs? 

Hi everybody: I'm trying to know how you can configure a VACL with multiples actions in a nexus 5x00.It's perfectly possible in Catalyst something like this:ip access-list GLBP-IP10 permit udp any 224.0.0.102/32 eq 3222!ip access-list ALL-IPs10 permi...

Hi,We need to upgrade the image on Nexus 1000 v,from 4.2(1)SV2(1.1a) to (5.2(1)SV3(1.2)) .When using the Cisco Virtual Switch Update Manager,will this upgrade the VSMs,VEMs and the Hosts?what if We don't need to upgrade the hosts at that step,how can...

Hello all I have a big Problem.We Need to Update our UCS FW (2.01 to 2.13 to 2.23)We have connect our Storage over direct attach ed FC Storage Ports. FI's are in FC Switch Mode.If I make the Update the VSAN Option "Enabled Default Zoning" doesen exis...

Hi , I have a full redundant architecture based on Exsi, (VDS or N1K), UCS and N5K (L2 and L3) in VPC configuration. it works but I am not sure of my configuration , perhaprs I read too many things.When I create a NLB  in Multicast mode, do I only cr...

I have a UCS system that I am using for some ESXi hosts.  These hosts are using iSCSI storage.  With my old stand alone hosts my physical NICs were handling traffic onto the physical cable up to the physical switch.  When that was the case, I used NI...

We have a UCS C22 M3S that I am attempting to load a custom Ubuntu build onto.  The build does not support software RAID, so it would detect the physical drives instead of the virtual drive.  It would install the OS, then at reboot, the software RAID...

Chassis - M5108FIs - 6248IOMs - 2204Uplink > Brocade ICX6450(Layer2) > Cisco 5525x(Gateway sub interfaces)Hi, I'm setting up a new, and my first UCS, single chassis with four blades to hosts a Hyper-V. The setup is quite straight forward, everything ...

Hi Folks I am tasks to setup a POC for UCS Mini and it is my first time performing such setup. There will be 3x blade servers installed. Can I get some pointers on what needs to be done to setup the UCS Mini? Appreciate it. RegardsAaron