Hi All I wanna know when I use the FI modes and which devices connected to the FI in each mode:1- Ethernet end host mode or EHV2- Ethernet Switching mode3- FC end host mode or NPV 4- FC switching mode Thanks in advance
Hi ,One of my customer is looking for blade failover so that the service profile & OS will be moved onto the blade seeamlessly without any manual intervention. I tried my best & Created the server pool of four blades & service profile for the same....
Dear All, I just take new USCC220 server.. when there is 1 TB hard drive along with this server.. But when i power on this server i did not find any HDD on system. Storage Sensor show there some device are present . But physically i check HDD LED ar...
I'm trying to determine if fully populating a chassis will cause a power contention issue under failure events. I'll explain the drivers for concern: UCS has power priority policies to give preference to certain systems in the event of a power loss...
HiWhen I configured service profile to a blade then deploy ESXi, It works correctly for a time then I found the following error " VIF 716 link state is down" as in the attached and the server management IP is pingable also the ESXi IP is pingable dur...
Hello Community,I'm practising with the Cisco UCS Manager Emulator, however I'm having a problem resolving the servers, see image. Can someone let me know where I'm going wrong?Carltoncpatte7372
I have UCS 5108 Blade Server Chassis (with two B200 M3 Blade Servers inside and two FI 6324) connected to Nexus N5k switch through 4x10GE links.I want to configure the two aggregated channels FCoE (vFC) from chassi to switch.All instructions I've bee...
Hello all I'm face with a problem of upgrading my vmware environment. Is it possible to upgrade my current vmware environment from vSphere 5.0 to vSphere 5.5 or v6 ?? Below is my current Cisco UCS specs. Cisco says no Vmware says yes. Has anyone tr...
Hi All I need to Know the definition and the USAGE (when I use each port) and the protocol used foreach of the FI port types1- FC uplink port2- FC storage port3- FCoE uplink port4- FCoE storage port5- Appliance portthanks in AdvanceAmr
hello,is there any way to rename a service-profile and or a service-profile template on the fly? Also, can I add / remove vlans from a template on the fly? Thanks.
Hello everyone!I need to upgrade firmware of p81e on a standalone c200 m2 server.The latest firmware I can find is 2.1(1a)However there is more recent versions in bundles for c-series managed by USC manager (like this: ucs-k9-bundle-c-series.2.2.2c.C...
Hello, I am new to ucs servers. We have a chassis. The blades are running esx5.0 I want to install 5.5. No need to upgrade just install 5.5 im not saving any info.I launch the KVM console and map the ISO. when I reboot though the server/blade just bo...
