Unified Computing System Discussions

Hello, I have a LSI MegaRAID SAS 9271-8i installed in a C220 M3 (in PCIe1). When I go to CIMC, I can see the adapter there and I can create RAID arrays. I can set the first logical drive to be the boot drive too without a problem. If I boot from ESXi...

The rackmounts are already powered off and removed from rack without decommisionning from UCS manager. Now the stale rackmount server is showing in UCS Manager. How to delete/decommision the rackmount now?

Hello,What is the proper way of configuring Boot Policy for C220M3 which has 4TB disks installed and is managed by UCSM 2.2? I try to configure Legacy and UEFI and I cannot install the OS in silent mode. The OS sees usupported device.Best regards,Krz...

Hi There doesnt seem to be a command to apply ssh on the vty line on the nexus platformIs this automatic or am i missing something as i have to write a security document to convert ios commands to nexus and i am stumped when it comes to ..#line vty (...

Hi, I have today installed a new IO Module into one of our chassis (2208XP into a 5508 Chassis).  But it has not come online.  There are lights on the IO module, however uplinks from that to the FI are down.  The ports on the FI are down.Error messsa...

     Hello,when I start the KVM launch manager and launch a KVM, he ask me for username and password (again?) and for an IP-address.AFAIK this should not be neccessary, shouldn't it?best regardsManfred

Hi All,I just install a Cisco UCS C22 M3 server in my environment, I have configured the CIMC IP Address and other necessary settings, after system reboot, the system keeps showing "PXE-E53: No boot filename received" "PXE-M0F: Exiting Intel Boot Age...

Hi All,How traffic flows inside the Chassis ? Please explain briefly as how the connectivity will be inside the chassis and traffic flow. If possible diagramatically. Thanks,Seven

how can i use the powertool to get all my blades and serial numbers?

Hello, I'm trying to add an additional vNIC for Service Profile.B200-M3, VIC1240+expander, IOM 2208XP, 4 links between IOM and FI 6248, firmware 2.2(1f).At the moment 7 vNICs are configured for this service profile. Service profile is associated with...

I have multiple FIs but everytime I setup one, I have to setup the service profiles and policies fro scratch Is there a way to export and import these profiles and policies into the new FI?

I cannot get any link lights on my fiber ports  the ucs fabric interconnects are connected to brocade. I have already configured the ports on the fabric as FC ports. I swapped out the cables modules and still no link lights any idea?

I'm getting the following fault on two of my B200-M3 blades after doing a firmware infrastructure autoinstall from 2.2(1d) to 2.2(3b).  Firmware update was successful on everything, so I'm not sure why something happened to the blades.The UCSM is cla...