Unified Computing System Discussions

Hi,Is standard access-list allowed on the Nexus 5548?  If it is allowed, can you please advice how do you do that?Also, when upgrading a Nexus 5548, do we upgrade the kickstart first then system nx-os?TIAPF

Hi Experts.I have three UCS C220 servers, out of three one server dedicated management ethernet port is giving very strange behaviour. It is working with one or two Cisco switches and not working working with any other switch, even with the laptop, i...

What is the correct configuration on the switch side (Nexus 5K) when configuring a monitoring port from the FIs?

                   I am trying to incorporate several UCS C200 servers into a Microsoft private cloud solution.  The FIs are running. 2.1(2a).  They have P81E VIC cards.  I have the latest drivers for Windows 2012.The private cloud includes integrati...

I need following network card firmware information through powertool command, please let me know if anyone knows about any command for this.                  

Hi,I need to forward traffic from our core switch a 3750 stack, to a vmware guest which sits on a UCS chassis. This is enable VOIP call recording. How can I configure our traffic to be sent to the vnic of our call recoding server on the UCS chassis? ...

I have a tricky question and need your adviceUCS customer, using ESXi 5.1 and vswitch, no DS nor N1kNFS with multiple shares on the same Netapp FilerESXi and Netapp are on the same Vlan and IP subnetWith standard balancing setup (originating virtual ...

I have two new c260 M2 servers with CIMC v1.5 (3d). The CIMC web interface is not accessible if I use the 10gig ethernet connection and specify CIMC to use the Shared LOM 10g with either active-active or active-standby. I'm using static IP address fo...

Hello, recently I installed the Zentyal OS on my server. It installed fine and booted properly. Then after a reboot the BIOS became corrupt.I've reflashed the bios using the recovery.cap file with a USB Drive, and the issue still persists. When it tu...

I'm unable to upload a certificate using the CIMC v1.5 (3d) web interface. I generated the certificate signing request, signed the certificate with my CA server, but when I try to upload the signed certificate, the web interface says "Certificate upl...