Unified Computing System Discussions

Hi,I want to change the UCS "QoS system Class" MTU for the "Best Effort" class' MTU from 9000 bytes to 9126 as per:http://www.cknetworx.net/?tag=ucs-jumbo-frames     and/orhttp://www.cisco.com/en/US/docs/unified_computing/ucs/UCS_CVDs/esxi51_ucsm2_Cl...

How to set a Power on password , Where you can provide a reference file? (C220/240/C22/C24/420/460.......)

Hello,I have a server Cisco UCS C22 M3 in which the fan speed not lower than 6000 RPM and generates a lot of noise. It is normal from turning on the computer and put at that speed?thanksgreetings

Hi everybody:I have a problem with a VSG version 4.2(1)VSG1(4.1)When I configure a simple rule in VNMC as permit all any any I can see in the VSG VSG1# show running-config rulerule Between31and32/PermitAll@root/Tenant1/VDC1/App1  action 10 permitrule...

Hello,In Equipment tab, Expansion module 3 and 4 is missing  from UCS Central.  I have 6296UP FI.                   Does anyway run into this issue?ThnaksHetal Soni

W2012 R2 with 2 veths (veth0 and veth1) (one connected to Fabric A, resp. B); team built with veth0 and veth 1; veth0 and veth1 in same Vlan, e.g. 10.LBFO (Load Balancing Failover): Switch independent, Hyper-V port2 such Hyper-V server in a UCS domai...

I see more and more partners and customers, that oppose to do boot from a network (be it FC, FCoE, iSCSI, PXE); they prefer installation on local disk, USB and / or SD. Any feedback from the field.One should also be aware, that W2012 (R2) we SMB V3 s...

Hi there,I have a question about UCS and FCoE – I don’t have a solution for my problem I configured my UCS with UCSM 2.1(3a) with a FCoE Uplink, default vsan, fcoe VLAN  99 – and the upstream nexus 5548up (nx-os 5.1.3) with npiv and fcoe  features – ...

Hi everyone,I  have a UCS 2.1 (1e) with 2 fabric interconnect.  Each Fabric have a FC port that is connected to a FC Fabric Qlogic 5600.  On this Qlogic, we have a old Xyratex F5402e with 2 ports connected to the Qlogic.  I have configured a Zone tha...

A customer recently upgrade his C200 from 1.4(3l) to 1.4(3p)5. Upgrade went fine and the system is running properly, however, both the CIMC GUI and CLI report firmware version is 1.4(3p) (see below)Is this an expected behavior? Is this known bug or l...

I have an environment where different teams own different aspects of the UCS environment. For example, operations is responsible for the environment and physical hardware, architecture is responsible for the configuration (policies, pools, profiles),...