Unified Computing System Discussions

HiI just received a new UCS C200 M2 with a seperate LSI 9260-4i MegaRAID SAS HBA card. I have installed the card and connected the SAS cables and LSI battery-backup unit (BBU).When I turn on the server, it recognizes the card, but appear a message of...

Hi Guys,AFAIK, FI 6120XP has two MGMT interfaces:MGMT0: used for out-of-band management;MGMT1: for future use. Could you please confirm if this information is correct?I'm asking this because today I have two FI 6120 in a cluster configuration with bo...

Hello Experts ,Would anybody help if there is a way to disaable a CPU on a UCS C220 server ?Is there a jumper that is used for this purpose ?!!ASAPThanks guys

HI Team ,VCE team suggested us to upgrade the following inorder to support it.Kindly suggest how to achive this.I am new to UCS & dont have enough knowlegde about it.Pls help Cisco C200 M1/M2 firmware upgrade from 1.1(1d) to 1.4 (3c)2Cisco UCS firmwa...

          I am trying to connect UCS (B200 M2, FI 6120XP, M81KR) to iSCSI IBM DS3512 (dual storage controllers) using appliance ports. It should be 1 GB link, MTU 9000, no boot from iSCSI.  Cannot make it working ,   cannot ping from esxi5 blade to t...

Hi,I have the following scenario, Cisco UCS chassis with 2 Blade B440 placed in slot 5 and 7.The blade in slot 5 is taking some time but the VIFs get pinned (FI Uplink) after approx 3 min.as for the server in slot 7 the VIFs using the adapter 2 remai...

I need to replace both IO modules (2104XP) in a chassis. Does any have the correct procedure to remove and replace a new IOM? Should I do the one attached to the secondary FI first? Do I need to failover the FI to replace the 2nd IOM or can I just sh...

                   Hi,I have the current setupUCS chassis (4 uplinks) --> FI --> (Port channel) --> N5K --> (port channel) --> VSS 6500I configure port channel between IO Module and the FI by changing to policy to "Port Channel" and set the link to 4...

Dear all:Document Cisco UCS Manager VM-FEX for Hyper-V GUI Configuration Guide, Release 2.1.pdf say install vmfex_tools-xxx.msi can config port profile,But I can not find this file.Have everybody know?

Hi,Our UCS C210 M2 is not working. I have intsalled CUCM and Unity Connection in the UCS server. The UCS server is not reachable at all. No Ping or any other connectivity. On physical monitoring, I can see an amber color led on one of the disks. And ...

Hello everyone,I have configured the Nexus speed at 1000 speed. SFP is GLC-T . As you can see below the SFP is model number GLC-T. It is supported on the Nexus 5549UP.Also set duplex to auto on interface but no luck,still getting not connected issue,...