Hi,while first time setting up Nexus 1000v i created some uplink port-profiles. Now, I created new, production, uplink port-profiles and move my vmnics to that new port-profile but can't delete old port-profile because there is still port-channel int...
Hi.Is it possible to enable/add a vmotion port-profile after the hosts have been migrated into the Nexus DVS?Hosts are ESXi4.1 Update 1 with a single vmk0, dual nic's.From the documentation I have, we need to create additional vmk groups before addin...
What layer are FI's in the Cisco hierarchical network design model?Is this a straigh up question? We have a Nexus 7k's for our Core and the FI's Port-Channel to them. So to me they would be Distribution Layer. But when we attach to Isilon NAS devices...
I am creating Template frot the server and when I try to accosiate it to server it gives myour changes will cause a configuration faluire can not derived wwnp from veirtualized port ??please advice hi I try to make the wwnp from pool and it succedd a...
Does anyone confirm me whether I can connect FI to both direct attach FCoE storage and also SAN switches, as you can see in the attached network diagram?If yes, do I need FC Switch Mode to function? Any concerns I should consider?Or better solution w...
we create a Portchannel in the UCS but it show up in the switch and in the UCS show failed since no operatioma member f0727 with this error ??<faultInstack="no"cause="membership-down"changeSet=""code="F0727"created="2012-01-30T10:25:46"descr="lan Mem...
Hi Experts,Need your advice on the issue that i'm currently facing. The problem is the UCS C200 M2 won't power up when the top cover is on. However, when i remove the top cover and switch it on it powers up. Probably a grounding issue or loose cable ...
Hi all,I'm working on a project which is about to set up a Cisco UCS Lab.Actually the topology looks simple and easy but there must be some missconfiguration on my side because i can't see any of IDs (P81E's wwpn and mac address info) from the Nexus ...
I have deployed two 1010 appliances, the upstream switches are two 6509 wihtout VSS.I cannot get the HA up.Output of show module is:Mod Ports Module-Type Model Status--- ----- -------------------------------- ...
Hi,Currently the UCS FIs are connected diretly to EMC storage using FC expansion module (FC Switch mode)I need to migrate these FC uplinks to N5K which will be connected to the storage (without down time).Is this possible?I have two FIs, can I discon...
Hello,In the PERFORMANCE tab in Fabric Interconnects (EQUIPMENT general tab in UCS Manager) one can see several columns, like %Utilization.What does the "%Utilization Tx" mean in a vNIC, whether it is the %Utilization regarding the physical port spee...
I have a C200 M2 server running ESXi that has some hardware issues. I have a new replacement C200 M2 and will need to transfer the old CPU, RAM, and harddrives to the new server.My question is, will I be able to boot up off the old harddrives in the...
I am planning to deploy UCS in the next month or so. It sounds like each UCS chassis requires four L6-20 receptacles.And we're getting two chassis. So I was looking to get a couple of Pulizzi like the onces below. Anyone prefer anothertype for bet...
Hi,In our lab i am testing with VMware 5 and Cisco UCS. We are running UCSM 2.0 (1m). I am now testing the part auto deploy. I have setup auto deploy in VMware and it is working ( first i had some issues with DHCP on windows that is solved in the UCS...
