02-19-2015 05:39 AM - edited 03-01-2019 12:02 PM
Hi All,
Is there is an issue if a UCS chassis 5108 has B200 blades with a mixture of CNA & ViC card? say some blades have M73KR & others have ViC1240.
would this work?
Thanks
Kass
Solved! Go to Solution.
02-19-2015 08:32 AM
02-19-2015 08:32 AM
02-23-2015 02:52 AM
Hi Manuel,
Thanks for the confirmation & the link. i will take a look at it.
Kass
02-23-2015 08:57 AM
Sounds good, also note that what matters here is that the adapter is supported by the blade and the firmware that is running.
02-24-2015 12:39 AM
i guess that it would be better to be on the same supported firmware level across all the blades.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: