cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
224
Views
0
Helpful
4
Replies

Blades with mixture of ViC/CNA

Kassim Ismail
Beginner
Beginner

Hi All,

Is there is an issue if a UCS chassis 5108 has B200 blades with a mixture of CNA & ViC card? say some blades have M73KR & others have ViC1240.

would this work?

 

Thanks

Kass

1 Accepted Solution

Accepted Solutions

Manuel Velasco
Cisco Employee
Cisco Employee
Yes this is supported, you can verify this using the compatability matrix below http://www.cisco.com/web/techdoc/ucs/interoperability/matrix/matrix.html let me know if this answers your question

View solution in original post

4 Replies 4

Manuel Velasco
Cisco Employee
Cisco Employee
Yes this is supported, you can verify this using the compatability matrix below http://www.cisco.com/web/techdoc/ucs/interoperability/matrix/matrix.html let me know if this answers your question

Hi Manuel,

 

Thanks for the confirmation & the link. i will take a look at it.

 

Kass

Sounds good, also note that what matters here is that the adapter is supported by the blade and the firmware that is running.

i guess that it would be better to be on the same supported firmware level across all the blades.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: