Cisco UCS M7 Blade with Windows 2022 Hyper-V vnic and vhba config

[naganagouda-patil]

I was configuring service profile template for ESXi hosts and followed best practices works fine, for Windows 2022 Hyper-v I am confused how to configure vnic, trunk port or native VLAN ? FI ports are port channeled by default, how to define vnic for Hyper-V hosts, for esxi hosts it is clear Mgmt, vMotion, Overlay, VM n/w dedicated vNIC's. Can anyone clarify on how to define vnic for Hyper

[Kirk J]

If hyper-V is not adding the 802.1q VLAN tag on traffic , then you can have UCSM do that at that specific vnic level with the 'native' vlan setting.  You only want to mark a specific vlan as native, when the above OS or nic driver in the  OS isn't/can't add the vlan tag itself.  If you are adding various vlan tags at hyper-v switch level for guestVM traffic, then you just simply 'allow' the various vlans at the vnic level which is trunking by default, without marking any of them as native.

Hope this helps,

Kirk...