How to configure UCS network with single 3850 upstream switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-11-2019 06:48 PM
I have 2 FI's and a UCS chassis with 4 M200 B3 blades. I only have one 3850-48U-E switch. Is there a good document on how to connect/configure the FIs to the single switch? I know this is not ideal but until I can afford another switch I want to start using the platform.
Any suggestions?
Thanks!
- Labels:
-
Unified Computing System (UCS)

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-13-2019 02:48 AM
Since its not a vpc/vss configuration, you can simply have port-channel/ether-channel of UCS uplinks or single uplink (upto your requirement) directly connected to 3850. Make sure to have spanning-tree port type as edge/port-fast(in case of UCS in end-host mode) OR network (in case of UCS in switching mode).
Hope this helps !
Regards,
MJ
