cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
565
Views
0
Helpful
1
Replies

I have enabled "standalone" mode in the CICM utility and now cant connect to KVM

Toddman15
Level 1
Level 1

Hello. I am VERY new to the UCS environment, and while trying to configure RAID on one of my servers (a racked c240, managed through UCS), I enabled "standalone" mode while kvm'd into the server I was working on. And of course, I can now no longer access the server. Is there some way in which I can undo this via the UCS Manager console, or would a keyboard and monitor need to be physically connected? The server is in another state.

 

The UCS Manager does seem to be aware of the server still, but the "overall state" shows as "inaccessible." Any help would be GREATLY appreciated.

 

Thank you,

 

Todd

 

 

1 Reply 1

Keny Perez
Level 8
Level 8

I have never seen that!   The server is marked as inaccessible cause you need to set it to factory defaults... attach the monitor and keyboard and try to move it back, but I am not sure that is possible  (again, I have never seen this before)... you might need to  remove the cables going to the fabric Interconnects and then reboot> F8 > Factory default and cable it again.

 

Let me know what you see... I am interested in confirming what other issue you may face now, hopefully none :)

 

 

-Kenny

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card