I've tried to connect Nexus 5596 ethernet port(1G) to a ISR C2951 Gi port. I have config the unified port for 1G. The router end is "up" but the switch status keep showing as "not connect". Is there any other additional configuration needed?
Nexus 5596#
interface Ethernet2/1
switchport access vlan 50
speed 1000
prnwsw31# sh int e2/1 status
--------------------------------------------------------------------------------
Port Name Status Vlan Duplex Speed Type
--------------------------------------------------------------------------------
Eth1/14 -- notconnec 50 full 1000 SFP-1000BAS
Ethernet2/1
transceiver is present
type is SFP-1000BASE-T
name is CISCO-AVAGO
part number is ABCU-5710RZ-CS4
revision is B2
serial number is AGM170220UY
nominal bitrate is 1300 MBit/sec
Link length supported for copper is 100 m
cisco id is --
cisco extended id number is 4
Software
BIOS: version 3.6.0
loader: version N/A
kickstart: version 5.2(1)N1(1b)
system: version 5.2(1)N1(1b)
power-seq: Module 1: version v5.0
Module 2: version v1.0
Module 3: version v1.0
uC: version v1.0.0.2
SFP uC: Module 1: v1.0.0.0
