Start up Inventory issue

[AL5555]

hi

I have installed the Cisco UCS Emulator 5aPE1. I added couple severs, chassis..etc and initial setup from start up inventory panel. The issue is that the chassis is not discovered neither on the UCSM nor on the topology view ? has any one faced this ? please advice .. thanks

[Keny Perez]

you are more likely to get a better answer here:

https://communities.cisco.com/community/technology/datacenter/compute-and-storage/ucs_management/content?filterID=contentstatus[published]~category[ucs-platform-emulator]

Upper right-hand corner.... Create > Discussion.

-Kenny

[Saurabh Kothari]

how many chassis have you configured?

is it more than 14? then it is likely to fail!

if not then did you restart the UCSPE?

Restart Emulator with this Hardware Setup

Restarts Cisco UCSPlatform Emulator to enable the emulated Cisco UCS Manager to discover the new hardware inventory configuration

Regards,

-SK