03-21-2018 02:21 PM - edited 03-01-2019 01:28 PM
When I look at the 'show configuration' output of the service profile on the CLI, i do not see the information of the inband configuration. Where would I see this from the CLI.
UCSM 3.2.2
Solved! Go to Solution.
03-21-2018 02:47 PM
03-21-2018 02:31 PM
You would scope to the service profile and run this command:
UCS-A# scope service-profile server 1/8
UCS-A /org/service-profile # show mgmt-iface in-band detail
03-21-2018 02:44 PM
This shows it is configured but no the explicit details that can be seen in the gui.
UCS3-A /org/service-profile # scope service-profile server 1/5
UCS3-A /org/service-profile # show config
enter service-profile HN1 instance
associate server 1/5
exit
UCS3-A /org/service-profile # show mgmt-iface in-band detail
External Management Interface:
Mode: In Band
Ip V4 State: Static
Ip V6 State: None
Is Derived from Inband Profile: No
UCS3-A /org/service-profile #
03-21-2018 02:47 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide