06-16-2020 07:34 AM
I have installed a UCS 220 M5 and have added ip address for CIMC and ESXi - both in same subnet. However, I can only be able to ping and access CIMS but not ESXi its trunk ports.
Can anyone assist, please?
06-16-2020 07:47 AM
Hi,
Share the configuration from ESXi and Switch side. thinking some misconfiguration related to VLAN or vSwitch.
06-16-2020 08:07 AM
Make sure you set up the network interface : ( allowed respected VLAN).
Check to make sure the virtual NICs on the ESXi hosts are in promiscuous mode to get the networking up.
check this article :
https://kb.vmware.com/s/article/1004099
what is the switch model here - also post switch side config?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: