vNIC pinning to HW port channel

[nvermande]

Hi there,

my question is the following:

given that you use the vic 1240 mLOM + 1280 mezz for "real" redundancy in a M3 blade + 2208 IOM, that creates 4 different port channels composed of 2 x 10GbE KR lanes each.

Then when creating a vNIC in your service profile and linking it to one specific fabric, this gives 2 port channel available per fabric. How is the vNIC pinned to the port-channel, round-robin or? Is there any way to identify those PC + pinning with the FI CLI or GUI?

Cheers,

Nicolas

[nvermande]

up?

[Will Banister]

I'm new to the UCS blade and chassis world and have the same setup as above, a 1240 and 1280 VIC in a B200 M3 blade. did you get an answer to your question?  how were able to build the vnic profiles with the mulitiple vics?