In this video we will use the Python Tool to update a group of systems
using a configuration file. We will walk through the encryption setup
process for the target CIMC as well as the remote share and how to
reference these encrypted files in an update sc...
In this video we will use the Python Tool to update a single system by
passing configuration flags and options through the CLI to a remote
target. This is the recommended update process for a one-time update to
a single system.
in My Videos)
In this video we will use the Microsoft Tool to update a group of
systems using media attached through NFS and WWW at the same time. We
will review using this system for the first time including a step by
step overview of how to save a configuration file,...
I'm trying to test the RAM in one of our blades using the Diag ISO https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/ucs_diagnostics/b_UCS_Blade_Server_Diagnostics_User_Guide-2-0/b_UCS_Blade_Server_Diagnostics_User_Guide-2-0_chapter_01.h...
I'm trying to connect the US FIs to direct attached storage, and when I go into the FIs to configure the fc ports, it's requiring that the storage ports start on the left and go to the right, with the ethernet ports on the right side. I've set up th...
Hello, I have an issue with a UCS C220 M3 in that it is in a continual boot loop and can't even get to the boot selection menu. This occurred while I was using the HUU to upgrade the CIMC and BIOS. After the reboot it has been in this state. After a ...
Hi we have B200 M4 UCS servers, and we also have 2 sites (Same domain, but different Vlan information) I need to move 1 blade from the chassis in 1 site to the chassis in the other site. We also need to rename it, don't know what the steps are. Also, if w...
First time working on a UCS server. I have a new C2205 M5 that I'm setting up. Two drives are installed, and are present under physical drive info in CIMC & SCU. But, neither drive is listed as an available physical drive to configure for RAID. &...