6248UP Fabric Interconnect HA functionality not ready

[Danny Sandner]

Hey Cisco community,

last night I received two "Information" messages from UCS:

Fabric Interconnect A, HA functionality not ready

Fabric Interconnect B, HA functionality not ready

A "Resolved" message I didn't received. Now I checked UCS, but can not found any problems:

ucs1-B# sh sys fi
UCSM:
    Running-Vers: 2.2(1d)
    Package-Vers: 2.2(1d)A
    Activate-Status: Ready
ucs1-B# sh clu ex
Cluster Id: 0xba377bdcbbd811e3-0xa77a002a6a7ff0e1

Start time: Wed Jul 16 07:22:22 2014
Last election time: Wed Jul 16 08:08:13 2014

B: UP, PRIMARY
A: UP, SUBORDINATE

B: memb state UP, lead state PRIMARY, mgmt services state: UP
A: memb state UP, lead state SUBORDINATE, mgmt services state: UP
   heartbeat state PRIMARY_OK

INTERNAL NETWORK INTERFACES:
eth1, UP
eth2, UP

HA READY
Detailed state of the device selected for HA storage:
Chassis 1, serial: FOX1736GWMY, state: active
Chassis 2, serial: FOX1736GWKV, state: active
Chassis 3, serial: FOX1815GDW8, state: active
ucs1-B# exit

Can some tell me, what happened? We have four chassis, three are quorum chassis. The only thing I did yesterday, I created two disjoint L2 network and pinned some VLANs to different up-link port-channels. Po10 - VLAN 100, Po66 - VLAN 101,102, 117. Po10 is connected to a test environment with Nexus, Po66 is connected to the productive environment with Catalyst 6509. I can not imaging that is concerning with the HA issue.

Many thanks,

Hugo

[Walter Dey]

Hallo Hugo

Don't think that this is related to your disjoint vlan configuration change.

I understand that this was a transient, and no remaining error message exists.

I would you check the error log for any events previous to this one.

Walter.

[Danny Sandner]

Hi Walter,

I've checked the event log. There are many log every ten minutes from "sys/user-ext" and "sys/pki-ext".

Around 01:13:40 AM and 01:25:40 AM there are some events of the fabric. I attached the event log of that time period. Unfortunately the time stamp format is crashed, so you have to read the log from down to up. :)

I don't understand, why this happens in the night, nobody has triggered that. Are those some "self health check" tasks?

/Hugo

[Walter Dey]

Hallo Hugo

Do you see anything weird under Faults and/or Audit Logs ?

Walter.

[Danny Sandner]

Sry for the late response.

No abnormality in audit log. Only the "scom local user" logs in and out for monitoring.

Can you tell me, how I can see old faults in the UCSM? I only the active faults.

/Hugo