Re: Adding additional direct attached iSCSI storage on different vlan to UCS
I'm not sure I fully understand your current topology.
If you are not doing iSCSI boot from san, I would think you could simply modify your current vnic that carries iscsi traffic to allow/trunk your additional/new iSCSI vlan. Then add an additional vmk iSCSI port bound with new vlan to the same vmnic.
Ideally, you would create an additional vnic, with just the new iSCSI vlan, and have the additional VMK iSCSI port bound to it's corresponding vmnic.
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•This field guide is meant to be used by customers for cleaning up an existing HyperFlex Edge deployment for the purposes of reinstalling.
•The procedures in this guide are DESTRUCTIVE. Make sure all VMs and data are backed up before proceedi...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...