cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
407
Views
0
Helpful
2
Replies

Adding new B200 M3 Error

molivere17982
Level 1
Level 1

Hello all.

I've added a new B200M3 to my chassis and created a clone of one of my existing B200M3 profiles and I'm getting the following error. I've never seen this before and attached a picture

 

 

2 Replies 2

Kirk J
Cisco Employee
Cisco Employee

You might want to confirm that the blade is running a matching CIMC,BIOS, Board controller firmware versions that come from the same package.  I've seen some similar messages where a CIMC is updated but not the BIOS.

 

Kirk...

AFROJ AHMAD
Cisco Employee
Cisco Employee

Hi , 

Server is stuck during Service profile association.

Follow the below steps #

Go to Service profile of this server  >> Removed management package from service profile

Then  assosciate service profile.

 

 

 

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: