I am studying for my DCT and find the UCSPE a very big help. My question is: Is there a way to do an initial setup Fabric Interconnects such as through GUI/Colsole and then add the second fabric interconnect? I am using UCSPE 2.2.5a as far as I can tell that is what the DCT exam is based on, but I am willing to go to a different version if it is not supported on this one.
Thanks so much!
I am more or less looking for the screen in the attached image!
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•This field guide is meant to be used by customers for cleaning up an existing HyperFlex Edge deployment for the purposes of reinstalling.
•The procedures in this guide are DESTRUCTIVE. Make sure all VMs and data are backed up before proceedi...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...