After upgrade to 1.4(3p)5, C200 reports wrong version

[gtlalpac]

A customer recently upgrade his C200 from 1.4(3l) to 1.4(3p)5. Upgrade went fine and the system is running properly, however, both the CIMC GUI and CLI report firmware version is 1.4(3p) (see below)

Is this an expected behavior? Is this known bug or limitation?

Is there any way to have evidence the firmware was updated to the correct version?

Should customer open a Service Request to investigate this further?

Thanks in advance.

Gabriel Tlalpachicatl

VCE Customer Advocate

[Keny Perez]

Gabriel,

Before opening a case, can you provide the output for the following?

-A# scope chassis

-A/chassis# scope firmware      <<< and from here a  "show detail"

-Kenny

Cisco Support Community is also present in Spanish:

https://supportforums.cisco.com/community/spanish/data_center

[gtlalpac]

Thank you Keny.

Here is the requested output

It should show 1.4(3p)5, shouldn´t it?

Is this a bug?

Thanks,

Gabriel