I would make sure all the paths look good going to your FC switches . You can check the logs on Brocades if your using them or MDS switches. Make sure you have primary and secondary targets in your boot policy . Check your hosts do they have Dead paths on your Fiber connections ?
When ESxi loads up ... it loads into memory . So even a disconnect might not be painful but if its trying to write to a debug log on the LUN that might cause a crash cause it cannot get there .
Was trying to get neworking to work on a new Ubuntu install on a UCS server. I did a "shutdown -r" and rebooted the server. Now it seems to be stuck in the Aptio setup utility. I either choose "save and exit" or exit without saving changes and I am brough...
Just wonder we recently try to add 2 M200 with firmware 4.1.1b, our UCS manager version is 4.0.2d, we got error said cannot donwgrade. I know we can update ucs manager from 4.0 to 4.1, bur wonder we can downgrade
OpenStack Neutron project offers pluggable framework means you can extend the capability of Neutron by orchestrating the Neutron functions to your upstream networking gears. For example, if you have provisioned a VLAN tagged Neutron network in Op...
https://soundcloud.com/user-327105904/s7e25-from-the-office-to-anywhere-empowering-secure-remote-work-with-cisco-vdi-solutions As organizations have had to rapidly respond and transition in the face of swift change, Cisco VDI solutions have enabled ...