Hi Team,I have a blade B480 M5 with 6146 CPU , I am planning to install redhat 8.9 which is supported starting from 4.2(3) but looks like the CNA Adapter does not support on 4.2(3) for this matrix but 5.0(1) is supporting this 1340. Is there any issu...
Hello,We are going to setup X series newly in one of our locations. Just wanted if there are any best practices to be followed and also need to know if this has to be set up in UCSM or IMM Mode as the datasheets for X series 9508 Chassis are having M...
Hi,I am having a weird issue with KVM Launching in a B200 M5 Blade. When I am trying to launch the console without the service profile, I can get to the console normally, whereas when I am launching the console post association of service profile. I ...
We have been asking our Cisco contacts for a long time for self-paced Intersight training (similar to what they have for UCS & the data centre technologies).To my pleasant surprise I got a mail on 20 Jan about new Cisco U. content which includes Cisc...
We have a Server configured with SAN Boot, where we zoned and configured the target details. But we had rebooted the server for some request after which server is not booting to OS.Zoning is configured Properly.Boot Policy Configured ProperlyPlease h...
Hello,I am working on some legacy gear which we do not have support for but are not ready to decommission. Two questions:Questions 1:Our FI's and blade are running on older firmware: 4.0(4d)Which does appears does not support 7.0.3, but is this irrel...
All, We have deployed many VMware vSphere / vSAN clusters over the years on UCS M5 and M6 hardware. In those cases, the Cisco HBAs were always on the VMware vSAN HCL. In the case of the UCS M7 series, the only HBA available is the UCSC-SAS-T-D, and...
Hi,We have a cluster of Cisco Hyperflex systems and looking to replace two failed HDDs. These failed SAS drives are visible as "Blacklisted". Please advise if any special precaution is required while replacing these HDDs as I have seen some posts com...
Hello guys,I'm trying to configure UCS-C240-M7 server in Cisco ccw. I'm getting the following error after configuring, Please note that this product may not be purchased outside of the approved bundles. Please use MLB: UCS-M7-MLB. (CE202322)When I lo...
Hi I am beginner with UCS. I just began to review UCS documents and watch some video. but i still has some confusion on it. After all connetions in UCS are completed, we are going to migrate host servers to UCS servers. My question is how we can migr...
Have a customer that wants to connect their NetApp AFF150 to their 6300. The NetApp only supports 10GbE, is it possible to use a CVR-QSFP-SFP10G adapter on the FI side and set the port to 10GbE and it function ok? Having a hard time finding clear ...
I am trying to converts ports from Ethernet to FC on UCS but the slider is starting from left to right instead of right to left. Is this the new firmware?.
This is a newly set up C220 with a new CPU, memory and drives. The server was running great for about a week. Then we started to do some setup things with ESXi and that's when the server shut off unexpectedly. After that the only thing the server doe...
We have added additional Hard disk to UCS box,to mount the disc to existing data store do we need to restart the UCS box?
Hi experts, TLDR; How do I get the same information as shown in the screendumps below (of a UCS Chassis managed by UCS Manager) for our sparkling new UCS-X which can only be managed in Intersight? Specifically: How much power is being consumed/suppli...
