Resolved! More Sata ports 3.5” UCS C220 M5L
Hi everyone,How can I connect more hhds sata in my server c220 M5L I have 4 Sata HDDs but I need more like 12.Is it possible?Kind regards,Douglas
Forum Posts
Dear guys, I am having a trouble with Cisco UCS C220 M5. When I boot to CIMC, there is an error as picture "M.2 SWRAID configuration is not detected". I tried "Load Manufacturing default" but it did not work. Please help me. Thanks a lot
Is it possible to pull performance metrics from a set of 6454's running in IMM. We are using a 3rd party monitoring tool and would like to pull metrics vis SNMP or from REST API?
I could not find on cisco website, End-of-Life Announcement for the Cisco UCS 2208XP IOM.do you have any suggestions on where to find it?
Can just the battery be replaced on this?... If so what is a part number? This is on a 3160 that is EOL and beyond TAC Support.
Hello.Updated UCS 5108 from version 2.2 to 3.2. Why hasn't it been updated, let's skip this question.The update process was successful, but an error appeared in the UI - "Adapter 1 in server 1/1 has unidentified FRU".Found this article - https://www....
Have a customer that wants to connect their NetApp AFF150 to their 6300. The NetApp only supports 10GbE, is it possible to use a CVR-QSFP-SFP10G adapter on the FI side and set the port to 10GbE and it function ok? Having a hard time finding clear ...
Hi Guys,Just a quick questionI've let my Firmware lapse a little 2.0(1t) and need to get a 2.0 (3) version on for my new B200M3s.Can I jump from 2.0 (1t) to 2.0 (3b) in one go or do I need to go to 2.0 (2) in between. (Production environment 6248s / ...
I have a UCS C series server and its serial console is connected to a KVM switch. I SSH to the KVM switch to access UCS server console to try to get into CIMC utility during server bootup...But I typed CIMC password wrong multiple times and CIMC util...
For unknown reasons, a blade in a slot has become status "Needs Resolution" with the UCSM errors shown below. Hardware is no longer on SmartNet support, can't call in a new case. N20-C6508UCS B200 M4 Warning is being raised and cleared every 20 minu...
Resolved! Impact of Acknowledge Chassis
I am working on understanding the impact of an acknowledge chassis process. Documentation would be great of this process. QuestionsWill traffic through the chassis stop?Will I loose connection to the SAN for my VMs?Will the blades in the chassis go ...
Resolved! Cisco UCS Unified Ports
I am trying to converts ports from Ethernet to FC on UCS but the slider is starting from left to right instead of right to left. Is this the new firmware?.
Have a pair of FI's in IMM mode running 4.2(2c) firmware. Trying to figure out which server firmware bundle to run on B200 M6 blades? The FI's are not listed in the interoperability matrix. There doesn't seem to be a definitive answer on how to deter...
Good day, I'm having an issue where the UCS S3260 will not allow me to create a VD from the Storage configuration on the CIMC I have tried assigning the Disks to the correct Zoning policy in multiple ways and every time I go to the Storage > Raid Co...
This is a newly set up C220 with a new CPU, memory, and drives. the server blinked the power LED orange one time, and the identification LED blue when plugged in. I have tried reseating all of the drives, memory, fans, and power supplies. I took a po...
