Unified Computing System Discussions

I need to configure NLB on N5K.as per cisco doc i am doing below configuration:interface Vlan10  no shutdown  ip address 10.1.2.1/24  ip arp 10.1.2.200 03bf.0000.1111mac address-table multicast 03bf.0000.1111 vlan 10 interface po 11 i am not able to ...

Hi, Could someone advise on whether there is a possible typo on the matrix for C220M4 and VMware 6.0 and LOM adapter driver version I have installed VMware ESXi 6.0 U2 Cisco version on a C220M4 - when I check what LOM driver comes with this it is ig...

i injected the 2012 r2 lom and storage drivers into windows 2012 r2 cd and installed 2012r2 fine but under device manager, i am sill seeing a bunch of devices without drivers. any idea what drivers im missing?

Hi Guys , hope you are all fine . I'm getting some error when trying to login to UCS Manager [see screenshot below] I'm familiar with this error when the primary FI is down , but here , both FIs are up [pingable] . Can someone please assist ? we ca...

Hi Guys , We got 5 new B200-M4 blades [see the screenshot attached , it got SSD HDD] and everytime i'm trying to ,mount CD/DVD , it said "the selected device could not be mapped" I tried all the available options in the Boot Order Policy for CD/DVD ...

We have 3 UCS C210 M2 running ESXi 5.5, how does Cisco handle the updating of the hosts to the latest version if the hardware is on the VMware HCL? These are running our Cisco CM and Unity 9.1 VM's.

How many active sessions can we have into UCS Platform Emulator?

I recently started a new position where we have three UCS C220 M3 servers running ESX 5.5.  The three are in a cluster and share datastores on a NetApp appliance.  Each server has two 600GB HDs installed.  My predecessor left a note stating that one ...

HI, We would like to change the name of vlan in UCS. We didn´t find how we do. Our configure is: scope eth-uplinkcreate vlan oldname 3275 scope org Virtualizedscope vnic-templ ethx.dvsVMs-Acreate eth-if oldname scope org Virtualizedscope vnic-templ...

I have completed the Auto install process a few times, but most have been with minimal production traffic in place.  I have one scheduled for this weekend and would like clarification on whether it is best practice to shutdown the network and storage...

Could you please direct me towards documentation on the Cisco website that would describing the process and steps to be take when updating from ESXi 4.1 to 6.0 for the UCS C210 M2 hardware. Is it simply a case of applying the following file update to...

Hopefully, this is a simple issue. I'm working with several C220M3 servers where we have installed a VIC 1225 in each server. The VIC is configured and working. We have a requirement for a 1gb NIC and would like to use one of the two built in NICs (L...

Hi, I just purchased some new hard disks (total: 5 x 500GB HDs) and plugged to C220 M3S server, which is running the BIOS version as C220M3.2.0.1b.0 (Build Date: 05/26/2014). I cannot select the option as RAID 10 on the below photo. Any idea?

I have power issue logs shown in my UC220 server and it gives   in server overall status " Server Fault "when i check the logs   i found the following :PVTT_P2: Processor 2 voltage is lower non-recoverablePVTT_DDR_GH: Memory channel (GH) voltage is l...