Unified Computing System Discussions

Hi All,We have a Cisco UCS rack mount server that currently has 4 drives configured in a raid with one being a spare.  We need to add storage so we have ordered 5 other drives and want to set up another raid volume with a spare..  So basically we lau...

What can i use to see how much bandwidth is being used on my fabric interconnect ports over a X period of time? Is there software available?

Does the firmware update immediately reboot the server or just update the firmware partition?  If so does IMC supervisor provide any warnings?  Will it update all components such as the VIC, RAID controller, etc.  The management guide is a bit lackin...

We are running SCOM 2012 R2 and trying to configure the UCS management pack but are seeing errors    < Data > Cisco UCS MP (https://fqdn:443) [Cisco.Ucsm.Proxy.LoadCache.ProbeAction.ps1] </ Data >  < Data > Could not load file or assembly 'file:///C:...

hello, i have two ucs c220m3 and now i have isntalled expe in one ucs and expc in one ucs.as now for expe, i created new vswitch 1 and assign 1 port from UCSC200M3 4 port network card but it is not pingable from DMZ switch.as port is showing connecte...

Hi,We have recently updated to Version 1.3(1a) of Ucs Central.  The new interface worked a few times now if we either try to switch from the login prompt even if already login we get this message:java.net.ConnectException: Connection refusedthis shou...

Hi,We've recently updated our UCS to the latest release, which finally adds support for VM-FEX for 2012 R2.  However, the supposed official method to manage VM-FEX for Hyper-V is using the UCSM Provider in Microsoft VMM 2012 R2.Has anyone been able t...

I have B200M3s with only 1240VIC. No additional mezzanine card. So I get 40GB throughput (20 to fab A) (20 to fab b) but on my 2208XP I only have 2 uplinks going to the FI. So thats 20GB per IOM Tops. Do I need to add more links between my IOM and FI...

What is the procedure to factory reset or recover aadmin password on a c3124 appliance

We have migrated NLB cluster from HP Servers to UCS Servers, and since migration to the Cisco UCS environment, customer have been complaining about issues with the NLB (Network Load Balancing) service on their systems.  These machines were previously...

Hello,i am having setup of below devices:2 FI 62482 UCS Chassis4 B200M35 B200M4now as i have discovered my chassis i created one service profiel from existing service profile and assign to B200M4 server but it is showing vNIC down as show in attached...

I have a 2911 where I installed this single wide UCS E blade.does anybody have any configuration for the router as it relates to the blade?i have installed the VMware on it already and able to put an ip on it so I can browse to the CIMC but not to th...