cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6216
Views
0
Helpful
20
Replies
Highlighted
Beginner

Re: Booting UCS from EMC VNX5300

Hi, I did not get any response. However, it is working fine now. It was the

problem with the way our team configured WWN, tks.

Prasad

On Fri, Feb 17, 2012 at 8:11 AM, jantkowiak <

Highlighted
Beginner

Booting UCS from EMC VNX5300

If you don't mind my asking -- how was that set up incorrectly?  (what is the right way?)

Highlighted
Beginner

Re: Booting UCS from EMC VNX5300

Hello,

It was complete oversight of my engineer. He has wrongly configured the WWN

of the VNX controllers in the Cisco UCS boot profile.

Prasad

On Fri, Feb 17, 2012 at 8:58 AM, jantkowiak <

Highlighted

Booting UCS from EMC VNX5300

Does anyone have details on the zone configuration required for this type of configuration?

We have FCoE direct connection to CLARiiON CX4-120.

FC Modules were added to the 6120s and connected a single MDS 9124.

We want use the MDS for zoning only - not the data path.

Highlighted
Cisco Employee

Booting UCS from EMC VNX5300

Hi Daniel,

The zone configuration will be the standard target-initiator configuration.  The zone information from the MDS will then be pushed down to the FI.

Booting UCS from EMC VNX5300

Brian - is there detailed documentation on how to configure?

CreatePlease to create content
Content for Community-Ad
Software Conformance Survey