C200 M2 RAID Configuration check

[luisrolocq]

Hi all

How can I check if the RAID configuration in my C200 M2 server is correct, the server was purchased from Cisco and I understand that it should be preconfigured with the correct RAID for Call Manager but I want to double check and make sure before I install VMW and create the virtual machines, I went in to the pre-boot CLI and ran the command -ldinfo -l0 -a0 and got the following out put:

Does this mean is correct ?? not to familiar with this and not sure how to check if Primary 1 has disk 0, and 1 and Secondary has 2 and 3, do I need to reconfigure RAID to match the config. in the release notes

Thanks 

[rewilkin]

Here is what your config should be.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/virtual/servers.html#wp53962

[luisrolocq]

Hi Reginald

Thanks for your replay but I know what my configuration should be, what I dont know is if the out put of the command displayed above is the result of a right configuration, since this was a tricky question I opened a TAC case and they confirmed that the C200 M2 purchased directly from Cisco comes preconfigured with RAID 10 and that the output indicates that is correctly configured.

Luis

[rewilkin]

Luis,

Glad TAC was able to get you an answer.  I figure if it came from us(Cisco)then it would have the config you ordered.  Thanks for being a customer.