08-19-2015 04:37 PM - edited 03-01-2019 12:20 PM
Hi,
I have a C240M4 with 2 x VIC 1225 cards
I would like to place some of the vNICS on the second card - but my placement order is not accepted/adhered to
I have tried the following placement order methods - all with the same results
Ive upgraded firmware from 2.2(3g) to 2.2(5b) - no success
Any help would be appreciated!
Cheers
Mike
08-19-2015 09:25 PM
Are the servers directly connected to the FI ?
http://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series-rack-servers/c240m4-lff-spec-sheet.pdf
The VIC features mentioned in this section are supported with the following
software releases: 2.0.6 (CIMC) and 2.2.5a (UCSM)
08-19-2015 09:50 PM
Yes, one of the 1225's connects the C240 to the FI's and it can be managed by the UCSM. The other 1225 is connected to N9K leaf switches
08-19-2015 09:58 PM
I think, although I can't find this in any documentation, that any VIC which is not connected to UCS FI, is not managable by UCSM, eg. service profiles,....
You see the hardware, but any vnic defined in the SP cannot be mapped to this adaptor.
08-20-2015 05:19 PM
Interesting - I'll rewire one of the servers and test
Cheers
Mike
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide