cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
334
Views
0
Helpful
1
Replies

CIsco CICM 4.x post install issue

Dean Brandt
Level 1
Level 1

Hi guys, I have a UCS C220M4 and it was running CICM 2.1 and CICM was accessible and functioning. I upgraded to 4.1 and I get the login page but any attempted login does not work, it just sits there, for days with a cog spinning endlessly. Have tried all the usual suspects in terms of browser. I am semi confident it does not use flash but have tried allowing flash, and turning flash off, any java cache also deleted but sure it doesn't use java either. Can semi ssh to it now and again but that is not a confident process either.

What am I potentially missing here?

 

1 Reply 1

Dean Brandt
Level 1
Level 1

SOLVED: Simply enter CIMC config (F8) from the boot prompt and set all CIMC settings back to default. When it reboots you will be asked to change password and the default is "password" and the CIMC will seek an IP via DHCP

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card