Cisco UCS and vSphere vDS LACP Teaming for Port Group
Is there any scenario where UCS B-Series will support the use of VMware's vDS Load distribution setting of LACP using DvUplinks to each fabric? I have found no way around the issue of the FI's not being clustered into a single channel for their network link but i have a customer insisting this is now supported with the latest release of UCS and the 13xx VICs.
LACP/switch assisted teaming can't function because the FI's don't share a data or control plane for the LACP PBDUs to coordinate over.
If you were talking about a rack server connected to two N5ks with VPC or to multiple ports on same N5k, then the upstream logical switch would be able to handle the LACP configuration, hashing, etc, as those would have a shared control plane.
New episode on the Cisco UCS X-Series Modular SystemListen: https://smarturl.it/CCRS8E23 Follow us: https://twitter.com/CiscoChampion The Cisco UCS X-Series Modular System simplifies your data center, adapting to the unpredictable needs of...
Join us for this #CiscoChat focused on how you can unlock the power of your hybrid cloud infrastructure. A panel of Cisco and industry experts will discuss Cisco’s hybrid cloud strategy and dive deep into the future-ready infrastructure behind it all.
How to collect UCS Rack Server Tech support (Command Line) ?
SSH to the server and login with Username and password
Just Copy and Paste below commands for different protocols
CIMC tech support will be collected on the remote machine in som...
Was trying to get neworking to work on a new Ubuntu install on a UCS server. I did a "shutdown -r" and rebooted the server. Now it seems to be stuck in the Aptio setup utility. I either choose "save and exit" or exit without saving changes and I am brough...