02-26-2018 05:49 AM - edited 03-01-2019 01:26 PM
We have a Hardware fault with of the UCS blade’s Processors. UCS blade is unable to recover Purple screen of Death even after reboots. Once rebooted blades has crashed on below blank screen can’t go further than Selftest
02-26-2018 05:51 AM
Looks like you have a hardware problem. I would open a TAC case for diagnosis and RMA if required.
02-27-2018 01:53 AM
Blade is NoT recognizing it's CPU's and not recovering crash state.
After PSOD, blade rebooted and it's going past the Self test, UCS manager is generating loads of error messages
03-21-2018 05:27 AM
Hello,
I had same problem 3 times.
It is mostly about Memory. If TAC engineer check all memory errors periodically, memory errors will be seen. That means, theese memories can cause PSOD problem. After replacing all of unhealthy memories, I haven't seen any PSOD for 3 months.
Best Regards.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: