Cisco UCS Platform Emulator, Release 2.2(2cPE1), adds support for the following new hardware:
New scalable M4 Blade Module for the UCSC-B260-M4 or UCSC-B460-M4 Blade Server added
New rack-mounted server UCSC-C460-M4 added
Support for the following storage accelerators:
New Software Features
Cisco UCS Platform Emulator, Release 2.2(2cPE1) includes the following new features:
Support for the scriptable vMedia feature to create mount points on Cisco IMC. The mounts are only configured and not actually mounted.
New tab Storage Controller added under Startup Inventory. You can drag and drop the storage controllers on the rack-mounted servers or the blade servers.
You can add the scalable M4 Blade Module in scaled (4S) or non-scaled (2S) mode.
The default configuration is changed to the M3 blade and rack-mounted servers.
NOTE: From UCS PE 2.2(1bPE1) onwards, UCS PE supports uploading the B-Series and C-Series server firmware bundles. Because of the large file sizes of the firmware bundles, UCS PE only supports uploading of only the stripped-down versions (attached to this document), which includes only the firmware metadata but not the actual firmware itself in the binaries. The stripped-down version of the firwmare bundles which contain metadata only of the B-series and C-series server firmware is reduced to approximately 50 kB in size.
Hi,I've got C220-M4 server located far away in data center. The problem is that I became server owner, however previous owner could not provide credentials to CIMC. So, I've got CIMC IP address but I cannot log-in.Is there any way to reset CIMC passw...
We have cisco UCSC-C220-M4S server running ESXi 5.5U3,now we are going to upgrade Firmware 4.0(2h) , followed by ESXi 6.5 U2 upgrade using below cisco customized image VMware_ESXi_6.5.0_10719125_Custom_Cisco_126.96.36.199_Bundle.zipRelease Date: 2019...
When will the Cisco Custom ISO for ESXi 6.7 U3 Install CD be ready? I've looked on VMware's site and it's not available. Vmware told me to ask Cisco and Cisco told me to ask VMware. I'm going in circles.
I am getting below error in each NICs and HBAs in newly mounted blades. 2 New chassis and few blades have recently attached in datacenter. Existing blades are fine, but error is showing on new blades only. Error: Virtual interface 1364 link state is ...
Hi,I am having issues with 4 fibre channel ports on my Cisco UCS and MDS environment.The connection and configuration on my FI-A is like below:interface fc2/1
channel-group 1 force
channel-group 1 force