Cisco UCS Platform Emulator, Release 2.2(2cPE1), adds support for the following new hardware:
New scalable M4 Blade Module for the UCSC-B260-M4 or UCSC-B460-M4 Blade Server added
New rack-mounted server UCSC-C460-M4 added
Support for the following storage accelerators:
New Software Features
Cisco UCS Platform Emulator, Release 2.2(2cPE1) includes the following new features:
Support for the scriptable vMedia feature to create mount points on Cisco IMC. The mounts are only configured and not actually mounted.
New tab Storage Controller added under Startup Inventory. You can drag and drop the storage controllers on the rack-mounted servers or the blade servers.
You can add the scalable M4 Blade Module in scaled (4S) or non-scaled (2S) mode.
The default configuration is changed to the M3 blade and rack-mounted servers.
NOTE: From UCS PE 2.2(1bPE1) onwards, UCS PE supports uploading the B-Series and C-Series server firmware bundles. Because of the large file sizes of the firmware bundles, UCS PE only supports uploading of only the stripped-down versions (attached to this document), which includes only the firmware metadata but not the actual firmware itself in the binaries. The stripped-down version of the firwmare bundles which contain metadata only of the B-series and C-series server firmware is reduced to approximately 50 kB in size.
We have Fabric A and fabric b each FI has 4 x 8 Gbps (8 total) - these are NOT connected via Port-channel We have concerns that these links may becoming saturated. How can i verify this from UCS manger? is it do-able or do...
Newbie post but I'm getting conflicting advice and would appreciate some thoughts. We have a UCS environment currently running 2.2(8L) and wish to upgrade to 3.X or 4.X to allow us to purchase and add some M5 blades in preparation for a vSphere upgra...
Running UCS 6232 16UP fabric Interconnects with firmware 4.0.2dConnecting a UCS C220 M5SX server with a VIC 1385 card in PCIe slot 1. Direct Attach.Making a policy for the server and attach it.Before attaching the server to FI, I had VMware ESXi 6.7 u2 in...
I have a B200 M4 with a UCSB-VIC-M83-8P that lost its connections all of a sudden. I reacknowledged the blade and all looks good now, but I'm trying to figure out what happened. What kind of action would cause this? I don't expect anyone...
Hi,I've got C220-M4 server located far away in data center. The problem is that I became server owner, however previous owner could not provide credentials to CIMC. So, I've got CIMC IP address but I cannot log-in.Is there any way to reset CIMC passw...