CONFIGURATION IMPORT NOTE: Importing configuration backups (All, System, or Logical) taken from the UCS Platform Emulator (UCSPE) to physical UCS Manager domains is not recommended or supported by Cisco TAC. UCSPE backups should only be imported to UCSPE domains.
New Hardware Features
Cisco UCS Platform Emulator Release 2.2(5aPE1), adds support for the following new hardware:
Added Haswell CPUs to the catalog.
Added support for the following Blade Servers:
Cisco UCS Scalable M4 Blade Module for UCSB-EX-M4-2 Blade Server.
Added support for the UCSC-PCIE-Q8362 network adapter.
Added the following templates for UCSB-B420-M4, UCSC-C460-M4, UCSB-EX-M4-1 and UCSB-EX-M4-2 servers:
New Software Features
Cisco UCS Platform Emulator, Release 2.2(5aPE1) includes the following new features:
Added support for time zone management.
Added support for scaled mode for UCSB-EX-M4-2 blade server
NOTE: From UCS PE 2.2(1bPE1) onwards, UCS PE supports uploading the B-Series and C-Series server firmware bundles. Because of the large file sizes of the firmware bundles, UCS PE only supports uploading of only the stripped-down versions (attached to this document), which includes only the firmware metadata but not the actual firmware itself in the binaries. The stripped-down version of the firwmare bundles which contain metadata only of the B-series and C-series server firmware is reduced to approximately 50 kB in size.
I am moving two chassis and a pair of fabric interconnects from one data center to another. When I turn up the FI's and chassis on the new network I want to use just 2 ports from IOM A and 2 ports from IOM B instead of the 4 ports each that they had ...
Hi Dear FriendsI have nexus 3064 Problem is Any NMS ( zabbix PRTG Cacti)Cannot show me sub-inteface for routed Port (no switchport interface)For example eth1/1.10 eth 1/1.20 Do not get Graph and traffic show zero in PRTG and Cacti And Zabbix
Hello Team,,we are migrating from N5K to N9K. The nexus 5K has ports working as FCoE, when we configure the same configuration on the Nexus 9k (vfc ..... ) , no FLOGI database have been found. and the vfc trunking state is stucked in (initializing).Any id...
Hello,I have a problem with a Cisco C240-M3 server.The front panel LEDs all light up green, the LED (D21) on the motherboard lights up permanently orange, see picture. Unfortunately, I cannot find complete documentation for the LEDs on the motherboar...