CONFIGURATION IMPORT NOTE: Importing configuration backups (All, System, or Logical) taken from the UCS Platform Emulator (UCSPE) to physical UCS Manager domains is not recommended or supported by Cisco TAC. UCSPE backups should only be imported to UCSPE domains.
New Hardware Features
Cisco UCS Platform Emulator Release 2.2(5aPE1), adds support for the following new hardware:
Added Haswell CPUs to the catalog.
Added support for the following Blade Servers:
Cisco UCS Scalable M4 Blade Module for UCSB-EX-M4-2 Blade Server.
Added support for the UCSC-PCIE-Q8362 network adapter.
Added the following templates for UCSB-B420-M4, UCSC-C460-M4, UCSB-EX-M4-1 and UCSB-EX-M4-2 servers:
New Software Features
Cisco UCS Platform Emulator, Release 2.2(5aPE1) includes the following new features:
Added support for time zone management.
Added support for scaled mode for UCSB-EX-M4-2 blade server
NOTE: From UCS PE 2.2(1bPE1) onwards, UCS PE supports uploading the B-Series and C-Series server firmware bundles. Because of the large file sizes of the firmware bundles, UCS PE only supports uploading of only the stripped-down versions (attached to this document), which includes only the firmware metadata but not the actual firmware itself in the binaries. The stripped-down version of the firwmare bundles which contain metadata only of the B-series and C-series server firmware is reduced to approximately 50 kB in size.
We have Fabric A and fabric b each FI has 4 x 8 Gbps (8 total) - these are NOT connected via Port-channel We have concerns that these links may becoming saturated. How can i verify this from UCS manger? is it do-able or do...
Newbie post but I'm getting conflicting advice and would appreciate some thoughts. We have a UCS environment currently running 2.2(8L) and wish to upgrade to 3.X or 4.X to allow us to purchase and add some M5 blades in preparation for a vSphere upgra...
Running UCS 6232 16UP fabric Interconnects with firmware 4.0.2dConnecting a UCS C220 M5SX server with a VIC 1385 card in PCIe slot 1. Direct Attach.Making a policy for the server and attach it.Before attaching the server to FI, I had VMware ESXi 6.7 u2 in...
I have a B200 M4 with a UCSB-VIC-M83-8P that lost its connections all of a sudden. I reacknowledged the blade and all looks good now, but I'm trying to figure out what happened. What kind of action would cause this? I don't expect anyone...
Hi,I've got C220-M4 server located far away in data center. The problem is that I became server owner, however previous owner could not provide credentials to CIMC. So, I've got CIMC IP address but I cannot log-in.Is there any way to reset CIMC passw...