CONFIGURATION IMPORT NOTE: Importing configuration backups (All, System, or Logical) taken from the UCS Platform Emulator (UCSPE) to physical UCS Manager domains is not recommended or supported by Cisco TAC. UCSPE backups should only be imported to UCSPE domains.
New Hardware Features
Cisco UCS Platform Emulator Release 2.2(5aPE1), adds support for the following new hardware:
Added Haswell CPUs to the catalog.
Added support for the following Blade Servers:
Cisco UCS Scalable M4 Blade Module for UCSB-EX-M4-2 Blade Server.
Added support for the UCSC-PCIE-Q8362 network adapter.
Added the following templates for UCSB-B420-M4, UCSC-C460-M4, UCSB-EX-M4-1 and UCSB-EX-M4-2 servers:
New Software Features
Cisco UCS Platform Emulator, Release 2.2(5aPE1) includes the following new features:
Added support for time zone management.
Added support for scaled mode for UCSB-EX-M4-2 blade server
NOTE: From UCS PE 2.2(1bPE1) onwards, UCS PE supports uploading the B-Series and C-Series server firmware bundles. Because of the large file sizes of the firmware bundles, UCS PE only supports uploading of only the stripped-down versions (attached to this document), which includes only the firmware metadata but not the actual firmware itself in the binaries. The stripped-down version of the firwmare bundles which contain metadata only of the B-series and C-series server firmware is reduced to approximately 50 kB in size.
Hello,I just picked up two C200 M1 machines second hand, and have run into an issue. I tested both before I purchased them, and they both POST'd fine so I purchased them. When I got them home I powered up one of them up. It was doing fine but seemed to st...
I have a customer that is looking to replace their 6296UP FIs with the new 6332-16UP model along with the 2304 IOMs.I found this guide - Migrating to UCS 6300 Series Fabric Interconnects and the UCS 2304 IOM The guide isn't quite as detail...