CONFIGURATION IMPORT NOTE: Importing configuration backups (All, System, or Logical) taken from the UCS Platform Emulator (UCSPE) to physical UCS Manager domains is not recommended or supported by Cisco TAC. UCSPE backups should only be imported to UCSPE domains.
New Hardware Features
Cisco UCS Platform Emulator Release 2.2(5aPE1), adds support for the following new hardware:
Added Haswell CPUs to the catalog.
Added support for the following Blade Servers:
Cisco UCS Scalable M4 Blade Module for UCSB-EX-M4-2 Blade Server.
Added support for the UCSC-PCIE-Q8362 network adapter.
Added the following templates for UCSB-B420-M4, UCSC-C460-M4, UCSB-EX-M4-1 and UCSB-EX-M4-2 servers:
New Software Features
Cisco UCS Platform Emulator, Release 2.2(5aPE1) includes the following new features:
Added support for time zone management.
Added support for scaled mode for UCSB-EX-M4-2 blade server
NOTE: From UCS PE 2.2(1bPE1) onwards, UCS PE supports uploading the B-Series and C-Series server firmware bundles. Because of the large file sizes of the firmware bundles, UCS PE only supports uploading of only the stripped-down versions (attached to this document), which includes only the firmware metadata but not the actual firmware itself in the binaries. The stripped-down version of the firwmare bundles which contain metadata only of the B-series and C-series server firmware is reduced to approximately 50 kB in size.
Hi,I've got C220-M4 server located far away in data center. The problem is that I became server owner, however previous owner could not provide credentials to CIMC. So, I've got CIMC IP address but I cannot log-in.Is there any way to reset CIMC passw...
We have cisco UCSC-C220-M4S server running ESXi 5.5U3,now we are going to upgrade Firmware 4.0(2h) , followed by ESXi 6.5 U2 upgrade using below cisco customized image VMware_ESXi_6.5.0_10719125_Custom_Cisco_18.104.22.168_Bundle.zipRelease Date: 2019...
When will the Cisco Custom ISO for ESXi 6.7 U3 Install CD be ready? I've looked on VMware's site and it's not available. Vmware told me to ask Cisco and Cisco told me to ask VMware. I'm going in circles.
I am getting below error in each NICs and HBAs in newly mounted blades. 2 New chassis and few blades have recently attached in datacenter. Existing blades are fine, but error is showing on new blades only. Error: Virtual interface 1364 link state is ...
Hi,I am having issues with 4 fibre channel ports on my Cisco UCS and MDS environment.The connection and configuration on my FI-A is like below:interface fc2/1
channel-group 1 force
channel-group 1 force